APU

From NESdev Wiki
Revision as of 01:43, 30 December 2010 by Jwdonal (talk | contribs) (→‎Note: Added a useful link that I happened to find by accident (linked from forums).)
Jump to navigationJump to search

The NES APU is the audio processing unit in the NES console which generates sound for games. It is implemented in the RP2A03 (NTSC) and RP2A07 (PAL) chips. Its registers are mapped in the range $4000-$4017.

For clarity, this reference describes the abstract operation of the APU, not the exact hardware implementation. As long as the behavior is documented, the exact kind of counter or shift register used to implement a particular behavior is essentially irrelevant; in any case, the exact hardware implementation can only be speculated on without access to very expensive chip-level reverse-engineering tools.

Registers Channel Units
$4000-$4003 Pulse 1 Timer, Length Counter, Envelope, Sweep
$4004-$4007 Pulse 2 Timer, Length Counter, Envelope, Sweep
$4008-$400B Triangle Timer, Length Counter, linear counter
$400C-$400F Noise Timer, Length Counter, Envelope, shift register w/ feedback
$4010-$4013 DMC Timer, memory reader, sample buffer, output unit
$4015 All Length Counter enable and status
$4017 All Frame Counter/Sequencer

Each channel has a variable-rate timer clocking a waveform generator, and various modulators driven by low-frequency clocks from the Frame Counter/Sequencer. The DMC plays samples while the other channels play waveforms. Each sub-unit of a channel generally runs independently and in parallel to other units, and modification of a channel's parameter usually affects only one sub-unit and doesn't take effect until that unit's next internal cycle begins.

The read/write status register allows channels to be enabled and disabled, and their current length counter status to be queried.

The outputs from all the channels are combined using a non-linear mixing scheme.

On board extra audio register reference

Note