IRQ

From NESdev Wiki
Revision as of 22:56, 24 October 2018 by Rainwarrior (talk | contribs) (adding CPU interrupts and Status register to see also)
Jump to navigationJump to search

IRQ (interrupt request) is a signal on the NES CPU. It is used to trigger a CPU interrupt.

If the CPU's /IRQ input is 0 at the end of an instruction, then the CPU pushes the program counter and the processor status register, sets the I flag to ignore further IRQs, and the Program Counter takes the value read at $fffe and $ffff.

This behaviour is masked by the CPU's interrupt-disable status flag. The SEI instruction disables IRQs, and the CLI instruction enables them.

/IRQ functions as an open collector input: it is normally 1, but any device on the CPU bus can pull it down to 0. An IRQ handler is expected to push any registers it uses, acknowledge the interrupt by writing to a port so that the source no longer forces /IRQ to 0, pull the registers back, and return with RTI.

Therefore if a program uses more than one source of IRQ, the priority between the conflicting interrupts should be handled in software.

Sources of IRQ on a Famicom or NES include

Source Enable Disable Acknowledge
APU DMC finish $4010 write with bit 7 = 1 $4010 write otherwise Disable then reenable, or play another sample
APU Frame Counter $4017 write with bits 7-6 = 00 $4017 write otherwise APU Status ($4015) read
MMC3 Write to $E001 Write to $E000 Disable then reenable
MMC5 Write $80 to $5204 Write $00 to $5204 Read $5204
VRC4/6/7 depends on specific IC
FME-7 write $81 to register $D write even number to register $D write anything to register $D
FDS Write $02 to $4022 Write $00 to $4022 Read $4030

See also