RP2C33 pinout: Difference between revisions
From NESdev Wiki
Jump to navigationJump to search
(read datasheet for MB81416 DRAM: neither its A0 nor A7 inputs are used in its column select. Actually, I probably need an oscope to figure what signals the address lines are relaying) |
mNo edit summary |
||
| (6 intermediate revisions by 3 users not shown) | |||
| Line 2: | Line 2: | ||
[[Family Computer Disk System]] ASIC RP2C33 or RP2C33A: 64-pin shrink DIP (FDS files) | [[Family Computer Disk System]] ASIC RP2C33 or RP2C33A: 64-pin shrink DIP (FDS files) | ||
.---\/---. | |||
(Rf) /ROMSEL -> | 01 64 | -- +5V | |||
(Rf) CPU A14 -> | 02 63 | <- XTAL2 | |||
(Rf) CPU A13 -> | 03 62 | -> XTAL1 | |||
(f) CPU A12 -> | 04 61 | <- ? (gnd) | |||
(f) CPU A11 -> | 05 60 | -> /RAS (r) | |||
(f) CPU A10 -> | 06 59 | -> /CAS1 (r) | |||
(f) CPU A9 -> | 07 58 | -> /CAS0 (r) | |||
(f) CPU A8 -> | 08 57 | <- R/W (rf) | |||
(r) PRG A6/13 <- | 09 56 | <- M2 (Rf) | |||
(r) PRG A5/12 <- | 10 55 | +> /IRQ (f) | |||
(r) PRG A4/11 <- | 11 54 | -> Audio (f) | |||
(r) PRG A3/10 <- | 12 53 | <- ? (gnd) | |||
(r) PRG A2/9 <- | 13 52 | +> SER OUT | |||
(r) PRG A1/8 <- | 14 51 | <- SER IN | |||
(r) PRG A0 <- | 15 50 | +> $4025W.2 (Disk 1=Read, 0=Write) | |||
(rf) CPU A7 -> | 16 49 | +> $4025W.1 (1=Reset transfer timing) | |||
(f) CPU A6 -> | 17 48 | +> $4025W.0 (1=Turn on motor) | |||
(f) CPU A5 -> | 18 47 | <- $4032R.2 (1=Write protected) | |||
(f) CPU A4 -> | 19 46 | <- $4032R.1 (1=Disk not ready) | |||
(f) CPU A3 -> | 20 45 | <- $4032R.0 (1=Disk missing) | |||
(f) CPU A2 -> | 21 44 | <+> EXT0 | |||
(f) CPU A1 -> | 22 43 | <+> EXT1 | |||
(f) CPU A0 -> | 23 42 | <+> EXT2 | |||
? <- | 24 41 | <+> EXT3 | |||
(rf) CPU D0 <> | 25 40 | <+> EXT4 | |||
(rf) CPU D1 <> | 26 39 | <+> EXT5 | |||
(rf) CPU D2 <> | 27 38 | <+> EXT6 | |||
(rf) CPU D3 <> | 28 37 | <+> EXT7/BATT | |||
(rf) CPU D4 <> | 29 36 | <- PPU A10 (f) | |||
(rf) CPU D5 <> | 30 35 | <- PPU A11 (f) | |||
(rf) CPU D6 <> | 31 34 | -> CIRAM A10 (f) | |||
GND -- | 32 33 | <> CPU D7 (rf) | |||
'--------' | |||
R - connects to LH2833 DRAM in later PCB revisions | |||
r - connects to DRAM (all revisions) | |||
f - connects to Famicom | |||
+ - output is open-drain, requires an external pull-up resistor | |||
Expansion audio mixing circuit schematic: | |||
1.2M | |||
+---/\/---+ | |||
+ | | 56K | |||
From RP2C33---||---/\/---+---|>o---+---+---/\/---+ | |||
(RP2C33.54) 1u 2M | | | |||
0.1u --- | | |||
--- | | |||
| | 100K | |||
GND | +---/\/---+ | |||
| + | | | |||
From 2A03----------------------------------/\/---+---||---+---|>o---+---To RF | |||
(Cart.45) 56K 1u (Cart.46) | |||
Notes: | |||
* PRG address bus is multiplexed, as is typical for DRAMs. | |||
* EXT port can be written via $4026 and read via $4033 | |||
Transcribed from http://green.ap.teacup.com/junker/119.html | Transcribed from http://green.ap.teacup.com/junker/119.html | ||
Revision as of 19:20, 22 April 2022
Family Computer Disk System ASIC RP2C33 or RP2C33A: 64-pin shrink DIP (FDS files)
.---\/---.
(Rf) /ROMSEL -> | 01 64 | -- +5V
(Rf) CPU A14 -> | 02 63 | <- XTAL2
(Rf) CPU A13 -> | 03 62 | -> XTAL1
(f) CPU A12 -> | 04 61 | <- ? (gnd)
(f) CPU A11 -> | 05 60 | -> /RAS (r)
(f) CPU A10 -> | 06 59 | -> /CAS1 (r)
(f) CPU A9 -> | 07 58 | -> /CAS0 (r)
(f) CPU A8 -> | 08 57 | <- R/W (rf)
(r) PRG A6/13 <- | 09 56 | <- M2 (Rf)
(r) PRG A5/12 <- | 10 55 | +> /IRQ (f)
(r) PRG A4/11 <- | 11 54 | -> Audio (f)
(r) PRG A3/10 <- | 12 53 | <- ? (gnd)
(r) PRG A2/9 <- | 13 52 | +> SER OUT
(r) PRG A1/8 <- | 14 51 | <- SER IN
(r) PRG A0 <- | 15 50 | +> $4025W.2 (Disk 1=Read, 0=Write)
(rf) CPU A7 -> | 16 49 | +> $4025W.1 (1=Reset transfer timing)
(f) CPU A6 -> | 17 48 | +> $4025W.0 (1=Turn on motor)
(f) CPU A5 -> | 18 47 | <- $4032R.2 (1=Write protected)
(f) CPU A4 -> | 19 46 | <- $4032R.1 (1=Disk not ready)
(f) CPU A3 -> | 20 45 | <- $4032R.0 (1=Disk missing)
(f) CPU A2 -> | 21 44 | <+> EXT0
(f) CPU A1 -> | 22 43 | <+> EXT1
(f) CPU A0 -> | 23 42 | <+> EXT2
? <- | 24 41 | <+> EXT3
(rf) CPU D0 <> | 25 40 | <+> EXT4
(rf) CPU D1 <> | 26 39 | <+> EXT5
(rf) CPU D2 <> | 27 38 | <+> EXT6
(rf) CPU D3 <> | 28 37 | <+> EXT7/BATT
(rf) CPU D4 <> | 29 36 | <- PPU A10 (f)
(rf) CPU D5 <> | 30 35 | <- PPU A11 (f)
(rf) CPU D6 <> | 31 34 | -> CIRAM A10 (f)
GND -- | 32 33 | <> CPU D7 (rf)
'--------'
R - connects to LH2833 DRAM in later PCB revisions
r - connects to DRAM (all revisions)
f - connects to Famicom
+ - output is open-drain, requires an external pull-up resistor
Expansion audio mixing circuit schematic:
1.2M
+---/\/---+
+ | | 56K
From RP2C33---||---/\/---+---|>o---+---+---/\/---+
(RP2C33.54) 1u 2M | |
0.1u --- |
--- |
| | 100K
GND | +---/\/---+
| + | |
From 2A03----------------------------------/\/---+---||---+---|>o---+---To RF
(Cart.45) 56K 1u (Cart.46)
Notes:
- PRG address bus is multiplexed, as is typical for DRAMs.
- EXT port can be written via $4026 and read via $4033
Transcribed from http://green.ap.teacup.com/junker/119.html
