Search results

...][[Category:Mappers with cycle IRQs]][[Category:Mappers with single-screen mirroring]]NES 2.0 Mapper 528 is used for the ''1995 New Series Super 2-in-1'' multic $A00C: Select nametable mirroring type (V/H/S0/S1).

...logic mappers]][[Category:Mappers with CHR RAM]][[Category:FDS conversion mappers]] * Nametable mirroring: Mapper controlled

*Mirroring: H or V (selected by software) ==Mirroring==

...like mappers]][[Category:Mappers with scanline IRQs]][[Category:Multi-ASIC mappers]]NES 2.0 Mapper 351 is used for Techline XB-xxx multicarts. ==NROM Mirroring ($4025, write)==

...onflicts]][[Category:Nintendo licensed mappers]][[Category:NES 2.0 mappers with submappers]] ...KiB of CHR, and NINA-001 should be used otherwise. The [[NES 2.0]] header with a [[NES_2.0_submappers#034:_BNROM_/_NINA-001|submapper]] can be used to for

...CartDB]][[Category:Mappers with ROM nametables]][[Category:NES 2.0 mappers with submappers]] * Nametable [[mirroring]]: Controlled by mapper

|mirroring=H or V fixed |mirroring=H, V, or 1 switchable

[[Category:Multicart mappers|201]]'''NES 2.0 Mapper 274''' denotes the ''Cartridge Story'' series of mul ==Inner Bank and Mirroring ($8000-$9FFF, write)==

{{DEFAULTSORT:150}}[[Category:iNES Mappers]][[Category:Mappers using $4020-$5FFF]] ...and its chip-on-board variant, '''SA-630'''. Using an eight-register ASIC with a fake "[[Sachen 74LS374N pinout|74LS374N]]" marking, it supports up to 128

|mirroring=H, V, or 1, switchable ...][[Category:Mappers with cycle IRQs]][[Category:Mappers with single-screen mirroring]]

...mappers with submappers]][[Category:MMC3-like mappers]][[Category:Mappers with scanline IRQs]]NES 2.0 Mapper 256 is used for games using the bankswitching ...ate ROM images using mapper 256, one must support bankswitching, nametable mirroring selection and IRQs using both the VTxx native registers (see the [[VT02+ PR

[http://www.romhacking.net/documents/362/ Disch's detailed list of over 50 mappers] at romhacking.net * iNES Mappers by Mapper Number *

...kB EEPROM, PAL16L8, latches and some gates. It allows to run the following mappers: ==Mirroring==

* the nametable mirroring type between Horizontal, Vertical, or Single-Screen, as needed by each game. ...t mirroring are to be included, otherwise the multicart can use hard-wired mirroring just like the original individual games.

...ne IRQs]][[Category:Mappers with large PRG RAM]][[Category:NES 2.0 mappers with submappers]] ! Ext. mode !! PRG bits !! $46/47 !! [[Mirroring#Single-Screen|1SM]] !! Extra WRAM !! Address mask !! PRG A21+ !! CHR A21+ !! CNROM latch

|mirroring=H, V, or 1-screen switchable ...53 mapper''' allows making a multicart of games that use multiple discrete mappers. It was assigned to [[iNES Mapper 028]].

|mirroring=H, V, or 1, switchable ...][[Category:Mappers with cycle IRQs]][[Category:Mappers with single-screen mirroring]]

{{DEFAULTSORT:347}}[[Category:FDS conversion mappers|347]][[Category:Mappers with CHR RAM|354]] ==PRG-ROM Bank Select #1/Mirroring Select ($8000-$8FFF, write)==

...][[Category:Multicart mappers]][[Category:in NesCartDB]][[Category:Mappers with scanline IRQs]] * Nametable [[mirroring]]: Controlled by mapper.

|mirroring=H or V (solder pad), 1-screen (solder pad or switchable), 4-screen fixed ...with bus conflicts]][[Category:Discrete logic mappers]][[Category:Mappers with flash save]]