Talk:Cartridge connector: Difference between revisions

From NESdev Wiki
Jump to navigationJump to search
Line 5: Line 5:


:: It make it very counter-intuitive if you're trying to do something related to Famicom<->NES conversion. I could see it being more useful if you're soldering something to the back of a toploader board, but other than that case I find it really confusing. Would you mind if I reversed it to be consistent with the Famicom version? I could reverse the numbers alongside it, if it's important that they stay the same. - [[User:Rainwarrior|Rainwarrior]] 21:12, 26 August 2012 (MDT)
:: It make it very counter-intuitive if you're trying to do something related to Famicom<->NES conversion. I could see it being more useful if you're soldering something to the back of a toploader board, but other than that case I find it really confusing. Would you mind if I reversed it to be consistent with the Famicom version? I could reverse the numbers alongside it, if it's important that they stay the same. - [[User:Rainwarrior|Rainwarrior]] 21:12, 26 August 2012 (MDT)
:: Ahh, I see that many Nintendo NES carts are numbered in this way, but I still think it'd be better just to have the numbering proceed upside down. As it is right now you would have to be looking at the card-edge upside down to see the same orientation as this diagram (and the numbers on the board would be upside down as well). - [[User:Rainwarrior|Rainwarrior]] 21:37, 26 August 2012 (MDT)

Revision as of 03:37, 27 August 2012

Orientation

I'm a little confused about this. Why does the pin orientation for the NES appear to be viewed from underneath the connector? Wouldn't it make more sense if it was a top-down view like on the famicom diagram? - Rainwarrior 20:45, 26 August 2012 (MDT)

Probably to be consistent with standard pinout numbering, which always goes counterclockwise and has pin 1 as top-left. It's also consistent with the edge on the mainboard. Not the best of reasons... —Lidnariq 20:53, 26 August 2012 (MDT)
It make it very counter-intuitive if you're trying to do something related to Famicom<->NES conversion. I could see it being more useful if you're soldering something to the back of a toploader board, but other than that case I find it really confusing. Would you mind if I reversed it to be consistent with the Famicom version? I could reverse the numbers alongside it, if it's important that they stay the same. - Rainwarrior 21:12, 26 August 2012 (MDT)
Ahh, I see that many Nintendo NES carts are numbered in this way, but I still think it'd be better just to have the numbering proceed upside down. As it is right now you would have to be looking at the card-edge upside down to see the same orientation as this diagram (and the numbers on the board would be upside down as well). - Rainwarrior 21:37, 26 August 2012 (MDT)