User:Lidnariq/NES-21G-CPU-72P
NES-21G-CPU-72P is an board used for some of Nintendo's test cartriges. As populated, it has:
- ① A CIC (for example, 3193A).
- ⑤ A 28-pin 8KiB SRAM for CHR (for example, NEC 64S20)
- ⑦ A 28-pin 32KiB UVEPROM for PRG (for example, Fairchild MBM27256-25)
- Permanently wired for vertical arrangement of nametables
This is noteworthy all on its own for being NROM but with CHR RAM.
Additionally, the SRAM uses both A13 and /A13 on its /CE and +CE inputs respectively.
Photos of existing boards have chips with date stamps of: 9004, 9005, 9002; and 901X, 9041, and 9035.
It is also the only Nintendo-made cartridge that ever implied a canonical direction for the EXP pins.
On the cartridge are silkscreen only for a number of other parts:
② 74HC04
M2 and SYSTEM CLK proceed on traces to the 74HC04:
signal ---INV---C---+---|>|---+---+---INV--- output
| | |
gnd---|>|---+ R C
| |
gnd gnd
"R" is given as 510k, the other component sizes are not specified on the silkscreen.
These are voltage doublers, and are being used to detect if the inputs are oscillating.
The SYSTEM CLK trace is cut.
One inverter inverts R/W, and the last input is tied to ground.
④ 74LS138
Only the /Y7 output is used. CPU A13, A14, /ROMSEL, M2 must be high. A12 and A11 must be low. This decode a region at $6000-$67FF.
③ 74LS32
R/W, W/R from the inverter, and /Y7 are combined to produce two clocks. As wired, when the CPU reads from $6000 EXP6 is driven low, and writes to $6000 latch the current EXP pins in the '374.
One OR gate combines the two voltage doubler outputs to serve as a "clocks bad" signal.
The last OR gate combines an unknown signal - possibly EXP5 - with the "clocks bad" signal and drives the output on EXP7.
⑥ 74LS374
In ascending order, the '374 latches EXP0, 1, 2, 3, 4, 9, 8, ?maybe EXP5?. However, its output is permanently enabled and this would cause the cartridge to not work in a real NES. Presumably it was intended that reads from $6000 would enable the output, and thus:
- Writes to $6000 - latch current EXP pins
- Reads from $6000 - report latched EXP pins, if the circuit were fixed
Finally, a resistor R3 ("3.3K"), a capacitor C9 ("51P"), and a 3-pin part labelled "TRI" appear to allow an unknown signal (maybe EXP5) to drive /IRQ.
Additionally, a blob of solder appears to be shorting the PRG UVEPROM's /CE and /OE pins permanently to ground. It is unclear how this works.
