Controller port pinout

From NESdev Wiki
Revision as of 19:36, 14 April 2015 by Tepples (talk | contribs) (Inline splice)
Jump to navigationJump to search

The NES controller pinout:

        .-
 GND -- |O\
 CLK <- |OO\ -- +5V
 OUT <- |OO| <- D3
  D0 -> |OO| <- D4
        '--'

(Directions are relative to the jack on the front of the NES)

The FC Twin NES/SNES combo clone uses Super NES controllers, whose pinout is as follows: (source: superfamicom.org)

 1 [oooo|ooo) 7  1:+5V  2:Clk  3:Out  4:D0  5:D1  6: I/O  7:Gnd

An adapter to use Super NES controllers on an NES (or NES controllers on an FC Twin) could be constructed as follows (leaving D3 and D4 unconnected):

        .-
 GND -- |7\
 CLK <- |21\ -- +5V
 OUT <- |3o| -- (D3)
  D0 -> |4o| -- (D4)
        '--'
  1. Buy two controller extension cables, one for NES and one for Super NES, and cut them apart. Strip the cut ends to reveal a small amount of bare wire.
  2. Using inline splice technique, wrap each wire from one with the corresponding wire from the other cable.
  3. With solder and a soldering iron, glue the wrapped wires together.
  4. With electrical tape, wrap each joint to insulate it.
  5. Apply heat shrink around the whole assembly.