NES 2.0 submappers/Proposals

From NESdev Wiki
Revision as of 01:53, 9 August 2015 by Lidnariq (talk | contribs)
Jump to navigationJump to search

This page collects proposals for NES 2.0 submappers that are not yet ready for implementation.

  1. Explain what game or ROM is incompatible with existing submappers.
  2. Explain how the proposed submapper should be implemented.
  3. Allow one or more other members of the community to independently verify that both 1 and 2 are correct. (We'll perform peer review, commentary, and possible revision/iteration here.)
  4. Allocate and document the new submapper, listing the relevant game/ROM.

When allocating new submappers, please consult kevtris' original proposal before choosing a number. If it is something he already assigned that we have just not adopted yet, use his existing assignment: submappers.txt

If there is no existing game or ROM that requires a submapper, it should not yet be allocated. There is no end to possible variations of hardware, and there is no need to speculate on the future. If you want to work on a project that will require a new mapper, engage the community and/or seek help from others. Do not pre-emptively add a new mapper to the spec until there is something we can run with it. The spec will still be here when you're finished your project.

005: MMC5

Status: Wishlist

Vertical split mode:
0: SL (all known hardware)
1: CL

If only one kind (battery or non-battery) of PRG-RAM present:
0: PRG-RAM is contiguous (EKROM, EWROM)
2: PRG-RAM is not contiguous; is split in half across two chips

If both kinds of PRG-RAM present:
0: Chip 0 is battery-backed (ETROM (note: verify this))
2: Chip 1 is battery-backed

Pulse waves volume:
0: R1 is 6.8kΩ (as in all games that use expansion audio)
4: R1 is 15kΩ (the nominal value of this resistor)

It is safe to leave the submapper number at 0 for all known games.

002, 003, 007: UxROM, CNROM, AxROM

Status: Draft

AxROM (mapper 7) is the only known licensed discrete logic mapper to unreliably come with bus conflict prevention circuitry. While no game documented in NesCartDB was released in one region on multiple board variants, several games did change boards when localized.

The following table is tentatively offered-
0: Normal (No advisory statement is made as to whether this game has bus conflicts) (uninvestigated AOROM)
1: Bus conflicts do not occur (ANROM)
2: Bus conflicts occur (AMROM)

Although all Nintendo-manufactured games using normal CNROM (mapper 3), normal UxROM (mapper 2), and inverted UxROM (mapper 180) had bus conflicts, apparently several unlicensed games require their absence, as does the updated version of Donkey Kong with the pie factory level.[1] This same table should be used for them, too.

CNROM with security diodes (mapper 185) has a different set of submapper definitions.

019: Namco 129 and 163

Status: Problem outline

Mapper 19 designates the Namco 129 and 163, which supports expansion sound, IRQs, and ROM nametables.

Different 163-using PCBs used a different resistor to change the volume of the expansion audio relative to the internal 2A03 audio. It is unclear if this variation warrants a submapper.

KH allocated a submapper specifically for the N163-using game Mindseeker. It is not known what is different about this game.

Tentative suggestion:
Mapper 19:
1: N163, expansion audio unused (mixing resistor: 0Ω)
2: N163, mixing resistor: 4.7kΩ
3: N163, mixing resistor: 10kΩ
4: N163, mixing resistor: 15kΩ
9: N129. Expansion audio is known buggy relative to N163, but other differences are not known.

Source: KH's submappers

034: BNROM / NINA-001

This iNES mapper unfortunately combines the unrelated BNROM and NINA-001 mappers.

034: 0

Normal. Both mappers can be implemented simultaneously without incompatibility.

Because the NINA-001 supports CHR banking and BNROM does not, the presence of more than 8 KiB of CHR implies NINA-001, and could be used to select between two exclusive mapper implementations.

034: 1

NINA-001 only.

  • (no extant games require this)

iNES Mapper 185

Status: Draft

A few NROM-like games were released on CNROM boards where all four bits of the latch were solely used as an anti-piracy measure. While a documented heuristic exists for which values were used, we tentatively suggest that the submapper here indicate the value to be written to the latch for normal operation (submapper = (latch&0x30)/4+(latch&3))

3210  
||||
|||+- Bit 0 (bank number)
||+-- Bit 1 (bank number)
|+--- Bit 4 (diode config)
+---- Bit 5 (diode config)

In the case that any of the bits are "don't care", use 0.